Fix: Linksys Velop Child Node Red Light Issue

Nowadays, users experience the Linksys Velop child node red light issue and want to know the reasons to fix it. If you are also suffering from the same issue and are not able to fix it after trying many things, then you have come to the right place.

In this article, we are going to tell you about the reasons that cause this issue and also give effective and useful hacks that will assist you to fix the trouble in no time.

First, we would like to tell you about the reasons that cause the red light on Linksys Velop child node so that you can better understand the post.

Reasons: Linksys Velop Child Node Red Light

Several reasons drag your Linksys Velop child node to illustrate the red light. Below we have mentioned some common reasons that cause this issue on the device:

Technical Glitches

You can face this issue when Linksys Velop child node becomes a victim of technical glitches due to over-usage.

Outdated Firmware

If you use the outdated firmware of the Linksys Velop child node then there is a high chance that your device shows the red light.

Excessive Distance

The long distance between the primary node and the parent node also could be the reason why the child node shows the red light.

No Internet Connectivity

Linksys child node also shows red light when it has a poor internet connection from the parent node.

These were the contributing factors that force your device to show the red light. Whatever the reasons are, you don’t need to worry because we have the most effective solutions for you that will assist you.

Fix: Red light of Linksys Velop Child Node

Reboot the Device

The very first solution that you need to follow is rebooting the Linksys Velop child node because it is seen that 8 out of 10 users were able to fix the same issue using this hack. So, there is a chance that you are in luck and will be able to fix the red light.

Plus, you will also eliminate the temporary hiccups from the Linksys Velop child node. To restart the device follow the following steps:

• First, you need to turn off the Linksys Velop child node.
• Remove it from the working wall outlet.
• Thereafter, wait for some time to recover the device.
• Put the device back into the power socket.

Now, turn on the Linksys Velop and check the node to make sure the issue is resolved or not. If not, then move to the next solution.

Update the Firmware

If you are not getting success by following the above hack, then update the firmware version of the Linksys Velop child node.

Although the Linksys node updates automatically but due to some reasons nodes are not able to update on time and are stuck on the old firmware which is not beneficial for the device. Because outdated firmware put the device at higher risk.

To check the firmware version, you need to access the Linksys Velop router login page.

Keep the Nodes Close (Child Node & Parent Node)

If you are still in the same situation, then check the distance between the child and parent nodes. If you found more than half the distance between the nodes then you need to remove it. Because in long-distance nodes face difficulty to communicate.

Hence, these are the hacks that you need to perform to solve the red light on the Linksys Velop child node.

Also read about Reset Netgear Router to Factory Settings.

Conclusion,

Now, you know why your Linksys Velop child node shows the red light and how you can fix it in no time. We hope the above-mentioned troubleshooting tips will assist you to resolve the red light.